[Sep 08, 2021] NSE7_SDW-6.4 PDF Dumps is essential on your NSE7_SDW-6.4 Exam Questions Certain Success!
NSE7_SDW-6.4 PDF Questions - Perfect Prospect To Go With NSE7_SDW-6.4 Practice Exam
NEW QUESTION 22
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Specify incoming interfaces in SD-WAN rules.
- B. Configure SD-WAN rules interface preference.
- C. Select SD-WAN balancing strategy.
- D. Specify outgoing interface routing cost.
Answer: B,D
NEW QUESTION 23
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link health-check
- B. diagnose sys virtual-wan-link intf-sla-log
- C. diagnose sys virtual-wan-link sla-log
- D. diagnose sys virtual-wan-link log
Answer: C
Explanation:
Explanation/Reference: https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/943037/sla-logging
NEW QUESTION 24
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link health-check
- B. diagnose sys virtual-wan-link intf-sla-log
- C. diagnose sys virtual-wan-link sla-log
- D. diagnose sys virtual-wan-link log
Answer: C
NEW QUESTION 25
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. The protected subnets should be set to address object to all (0.0 .0. o/o).
- B. ADVPN should only be enabled on unmanaged FortiGate devices.
- C. On the hub VPN, only the device needs additional phase one sett
- D. Each VPN device has a unique pre-shared key configured separately on phase one
Answer: D
NEW QUESTION 26
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. The 10 Mbps bandwidth is shared equally among the IP addresses.
- B. A single user uses the allocated bandwidth divided by total number of users.
- C. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- D. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
Answer: D
Explanation:
Reference:
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/885253/per-ip-traffic-shaper
NEW QUESTION 27
Refer to exhibits.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?
- A. The guaranteed-10mbps option must be selected as the per-IP shaper option
- B. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
- C. The guaranteed-10mbps option must be selected as the reverse shaper option.
- D. The reverse shaper option must be enabled and a traffic shaper must be selected
Answer: C
NEW QUESTION 28
Which statement about using BGP routes in SD-WAN is true?
- A. VPN topologies must be form using only BGP dynamic routing with SD-WAN
- B. Learned routes can be used as dynamic destinations in SD-WAN rules
- C. Adding static routes must be enabled on all ADVPN interfaces.
- D. Dynamic routing protocols can be used only with non-encrypted traffic
Answer: A
NEW QUESTION 29
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?
- A. The URL category must be specified on the traffic shaping policy
- B. The application control profile must be enabled on the firewall policy.
- C. The shaper mode must be applied per-IP shaper on the traffic shaping policy
- D. The web filter profile must be enabled on the firewall policy
Answer: D
NEW QUESTION 30
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
- B. Dead members require manual administrator access to bring them back alive
- C. Port2 might become alive when a single response is received from an SLA server
- D. SD-WAN interface becomes disabled and port1 becomes the WAN interface
Answer: A
NEW QUESTION 31
Which three parameters are available to configure SD-WAN rules? (Choose three.)
- A. Internet service database (ISDB) address object
- B. Application signatures
- C. URL categories
- D. Source and destination IP address
- E. Type of physical link connection
Answer: A,C,D
NEW QUESTION 32
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)
- A. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- B. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- C. It improves SD-WAN performance on the managed FortiGate devices.
- D. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- E. It acts as a policy compliance entity to review all managed FortiGate devices.
Answer: D,E
NEW QUESTION 33
Which statement reflects how BGP tags work with SD-WAN rules?
- A. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- B. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- C. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
- D. BGP tags match the SD-WAN rule based on the order that these rules were installed.
Answer: B
NEW QUESTION 34
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- B. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- C. It ensures route tags match the SD-WAN rule based on the rule order
- D. It tags each route and references the tag in the routing table.
Answer: C
NEW QUESTION 35
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. The 10 Mbps bandwidth is shared equally among the IP addresses.
- B. A single user uses the allocated bandwidth divided by total number of users.
- C. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- D. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
Answer: D
NEW QUESTION 36
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Configure the IKE mode to be aggressive mode.
- B. Use different proposals are used between the interfaces.
- C. Specify a unique peer ID for each dial-up VPN interface.
- D. Use unique Diffie Hellman groups on each VPN interface.
Answer: B,D
NEW QUESTION 37
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?
- A. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.
- B. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
- C. Check interval is the time to wait before a packet sent by a member interface considered as lost.
- D. The dead member interface stays unavailable until an administrator manually brings the interface back.
Answer: A
NEW QUESTION 38
Which diagnostic command can you use to show the SD-WAN rules interface information and state?
- A. diagnose sys virtual-wan-link neighbor.
- B. diagnose sys virtual-wan-link service
- C. diagnose sys virtual-wan-link member.
- D. diagnose sys virtual-wan-link route-tag-list
Answer: A
NEW QUESTION 39
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers. The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links. One link has random jitter and latency issues, and is based on a wireless connection.
Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD-WAN rules? (Choose two.)
- A. Configure an SD-WAN rule to load balance all traffic without VoIP.
- B. Place the troublesome link at the top of the interface preference list.
- C. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.
- D. Choose the suitable interface based on the interface cost and weight.
- E. Use the performance SLA targets to detect latency and jitter instantly.
Answer: C,E
NEW QUESTION 40
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Interface-based shaping mode
- B. Per-IP shaping mode
- C. Reverse policy shaping mode
- D. Shared policy shaping mode
Answer: A
NEW QUESTION 41
Which statement is correct about the SD-WAN and ADVPN?
- A. ADVPN interface can be a member of SD-WAN interface.
- B. Spoke support dynamic VPN as a static interface.
- C. Dynamic VPN is not supported as an SD-Wan interface.
- D. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
Answer: A
NEW QUESTION 42
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two.)
- A. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- B. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
- C. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
- D. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
Answer: B,D
Explanation:
Explanation/Reference:
NEW QUESTION 43
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. FortiGate has terminated the session after a change on policy ID 1.
- B. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- C. Changes have been made on firewall policy ID 1 on FortiGate.
- D. Firewall policy ID 1 has source NAT disabled.
Answer: B
NEW QUESTION 44
......
NSE7_SDW-6.4 Exam with Accurate Fortinet NSE 7 - SD-WAN 6.4 PDF Questions: https://www.prepawayexam.com/Fortinet/braindumps.NSE7_SDW-6.4.ete.file.html
True Fortinet Exam Extraordinary Practice For the NSE7_SDW-6.4 Exam: https://drive.google.com/open?id=1xM44cx1vvmcf671-7R6U0ZlO40qz4YiM