Fortinet NSE7_SDW-6.4 Real 2021 Braindumps Mock Exam Dumps
NSE7_SDW-6.4 Exam Questions | Real NSE7_SDW-6.4 Practice Dumps
NEW QUESTION 19
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )
- A. A peer ID is included in the first packet from the initiator, along with suggested security policies.
- B. A total of six packets are exchanged between an initiator and a responder instead of three packets.
- C. XAuth is enabled as an additional level of authentication, which requires a username and password.
- D. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.
Answer: B,C
NEW QUESTION 20
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It ensures route tags match the SD-WAN rule based on the rule order
- B. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- C. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- D. It tags each route and references the tag in the routing table.
Answer: A
NEW QUESTION 21
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)
- A. SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom
- B. The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces
- C. The initial session of an application goes through a learning phase in order to apply the correct rule
- D. The implicit rule overrides all other rules because parameters widely cover sources and destinations.
Answer: C,D
NEW QUESTION 22
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Shared policy shaping mode
- B. Reverse policy shaping mode
- C. Per-IP shaping mode
- D. Interface-based shaping mode
Answer: D
NEW QUESTION 23
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
- A. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
- B. SD-WAN member interfaces are affected by the SLA state of the inactive interface.
- C. Both SD-WAN member interfaces have used separate SLA targets.
- D. Port1 became dead because no traffic was offload through the egress of port1.
Answer: A
NEW QUESTION 24
Which statement reflects how BGP tags work with SD-WAN rules?
- A. BGP tags match the SD-WAN rule based on the order that these rules were installed.
- B. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- C. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
- D. VPN topologies are formed using only BGP dynamic routing with SD-WAN
Answer: D
NEW QUESTION 25
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?
- A. The web filter profile must be enabled on the firewall policy
- B. The URL category must be specified on the traffic shaping policy
- C. The application control profile must be enabled on the firewall policy.
- D. The shaper mode must be applied per-IP shaper on the traffic shaping policy
Answer: A
NEW QUESTION 26
Which components make up the secure SD-WAN solution?
- A. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
- B. Application, antivirus, and URL, and SSL inspection
- C. Datacenter, branch offices, and public cloud
- D. Telephone, ISDN, and telecom network.
Answer: A
NEW QUESTION 27
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. On the hub VPN, only the device needs additional phase one sett
- B. Each VPN device has a unique pre-shared key configured separately on phase one
- C. The protected subnets should be set to address object to all (0.0 .0. o/o).
- D. ADVPN should only be enabled on unmanaged FortiGate devices.
Answer: B
NEW QUESTION 28
Which statement is correct about the SD-WAN and ADVPN?
- A. Spoke support dynamic VPN as a static interface.
- B. Dynamic VPN is not supported as an SD-Wan interface.
- C. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
- D. ADVPN interface can be a member of SD-WAN interface.
Answer: D
NEW QUESTION 29
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set load-balance-mode source-ip-ip-based.
- B. Set source 100.64.1.1.
- C. Set cost 15.
- D. Set priority 10.
Answer: B
NEW QUESTION 30
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It improves SD-WAN performance on the managed FortiGate devices.
- B. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- C. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- D. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- E. It acts as a policy compliance entity to review all managed FortiGate devices.
Answer: A,E
NEW QUESTION 31
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. On the hub VPN, only the device needs additional phase one sett
- B. Each VPN device has a unique pre-shared key configured separately on phase one
- C. The protected subnets should be set to address object to all (0.0 .0. o/o).
- D. ADVPN should only be enabled on unmanaged FortiGate devices.
Answer: B
NEW QUESTION 32
What is the lnkmtd process responsible for?
- A. Processing performance SLA probes
- B. Flushing route tags addresses
- C. Monitoring links for any bandwidth saturation
- D. Logging interface quality information
Answer: C
NEW QUESTION 33
Which statement about using BGP routes in SD-WAN is true?
- A. Dynamic routing protocols can be used only with non-encrypted traffic.
- B. VPN topologies must be form using only BGP dynamic routing with SD-WAN.
- C. Learned routes can be used as dynamic destinations in SD-WAN rules.
- D. Adding static routes must be enabled on all ADVPN interfaces.
Answer: C
Explanation:
Explanation/Reference:
https://www.fortinetguru.com/2019/09/using-bgp-tags-with-sd-wan-rules-fortios-6-2/#:~:text=SD%2DWAN%
20rules%20can%20use,to%20the%20customer's%20data%20center.
NEW QUESTION 34
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- B. FortiGate has terminated the session after a change on policy ID 1.
- C. Changes have been made on firewall policy ID 1 on FortiGate.
- D. Firewall policy ID 1 has source NAT disabled.
Answer: A
NEW QUESTION 35
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers. The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links. One link has random jitter and latency issues, and is based on a wireless connection.
Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD-WAN rules? (Choose two.)
- A. Configure an SD-WAN rule to load balance all traffic without VoIP.
- B. Place the troublesome link at the top of the interface preference list.
- C. Use the performance SLA targets to detect latency and jitter instantly.
- D. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.
- E. Choose the suitable interface based on the interface cost and weight.
Answer: C,D
NEW QUESTION 36
Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface? (Choose two )
- A. FEC is useful to increase speed at which traffic is routed through IPsec tunnels.
- B. FEC transmits additional packets as redundant data to the remote device.
- C. FEC improves reliability which overcomes adverse WAN conditions such as noisy links.
- D. FEC transmits the original payload in full to recover the error in transmission.
- E. FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss
Answer: B,C
NEW QUESTION 37
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)
- A. It improves SD-WAN performance on the managed FortiGate devices.
- B. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- C. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- D. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- E. It acts as a policy compliance entity to review all managed FortiGate devices.
Answer: B,E
NEW QUESTION 38
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Specify outgoing interface routing cost.
- B. Configure SD-WAN rules interface preference.
- C. Select SD-WAN balancing strategy.
- D. Specify incoming interfaces in SD-WAN rules.
Answer: A,B
NEW QUESTION 39
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Shared policy shaping mode
- B. Reverse policy shaping mode
- C. Interface-based shaping mode
- D. Per-IP shaping mode
Answer: A
NEW QUESTION 40
What is the lnkmtd process responsible for?
- A. Processing performance SLA probes
- B. Flushing route tags addresses
- C. Monitoring links for any bandwidth saturation
- D. Logging interface quality information
Answer: D
NEW QUESTION 41
Which statement reflects how BGP tags work with SD-WAN rules?
- A. BGP tags match the SD-WAN rule based on the order that these rules were installed.
- B. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- C. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- D. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
Answer: A
NEW QUESTION 42
......
Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
Verified NSE7_SDW-6.4 Exam Dumps Q&As - Provide NSE7_SDW-6.4 with Correct Answers: https://www.prepawayexam.com/Fortinet/braindumps.NSE7_SDW-6.4.ete.file.html
Pass Your NSE7_SDW-6.4 Dumps Free Latest Fortinet Practice Tests: https://drive.google.com/open?id=1geQKcAj_ijvfzr6l8e5kgXP7ny3Xqt6U