[Nov 01, 2021] JN0-1362 Dumps PDF and Test Engine Exam Questions - PrepAwayExam
Verified JN0-1362 exam dumps Q&As with Correct 130 Questions and Answers
NEW QUESTION 18
Which two network availability features require a router to have two Routing Engines installed? (Choose two.)
- A. GRES
- B. nonstop routing
- C. JVRRP
- D. graceful restart
Answer: B,C
NEW QUESTION 19
You are designing several MPLS virtual routing and forwarding (VRF) instances on all provider edge (PE) routers. Routes within each VRF should be exchanged between all PE routers provisioned for that VRF.
For each VRF routing instance which two attributes must match on all related PE routers? (Choose two )
- A. interfaces
- B. VRF target
- C. router ID
- D. instance type
Answer: B,D
NEW QUESTION 20
You are designing a multi-site data center environment with data center interconnects between sites.
Which two statements are true in this scenario? (Choose two. )
- A. VPLS can be used to interconnect the multiple sites.
- B. EVPN with VXLAN can be used to interconnect the multiple sites.
- C. All data centers must be in the same Layer 2 broadcast domain and subnet.
- D. The data centers must be connected with a full mesh design.
Answer: A,B
NEW QUESTION 21
You are designing the physical redundancy for a service provider network and are checking for potential risks due to fate sharing.
Which two sources of fate sharing should you examine in this scenario? (Choose two.)
- A. hardware vendor
- B. building location
- C. fiber conduit
- D. MPLS LSP
Answer: B,D
NEW QUESTION 22
Exhibit.
You work for service provider B that wants to implement a hot potato routing policy on the network so that router C uses link C-A to reach service provider A's advertised routes and router D uses link D-B to reach Service Provider A's advertised routes Currently traffic from router C is traversing the core to exit the network on router B.
Referring to the exhibit, what are two design actions that would satisfy the requirements? (Choose two.)
- A. Configure new IBGP neighbors between routers C and A and routers D and B
- B. Configure the route reflector to send multiple copies of a route learned from different IBGP peers to its clients.
- C. Implement BGP-ORR
- D. Implement BGP-LS
Answer: A,B
NEW QUESTION 23
A customer reports that their RSVP LSP deployment faces scaling challenges as their network grows. You are asked to propose ways that the network can be optimized.
What are two ways that Paragon Pathfinder (formerly known as NorthStar) helps achieve this optimization? (Choose two.)
- A. offloading control plane state to a central controller
- B. creation of LSPs across different IGP areas
- C. faster detection of LSP failure
- D. reduction in LSPs due to optimal path selection
Answer: A,C
NEW QUESTION 24
You are designing a Metro Ethernet ring topology that requires a sub 50 ms failover.
Which two protocols will meet this requirement? (Choose two )
- A. Ethernet ring protection switching
- B. Link Aggregation Control Protocol
- C. Spanning Tree Protocol
- D. MPLS fast reroute
Answer: A,C
NEW QUESTION 25
Which statement is correct regarding classifiers in CoS?
- A. Classifiers are used to change DiffServ values on outgoing packets.
- B. Classifiers are used to separate traffic into different forwarding classes.
- C. Classifiers are used to define the transmit rate for forwarding classes.
- D. Classifiers are used to route traffic between routing instances.
Answer: B
NEW QUESTION 26
Your customer is deploying a multitenant data center and needs help with the WAN edge design.
What are two mam design considerations for this environment? (Choose two.)
- A. control plane redundancy
- B. NAT requirements
- C. unified threat management
- D. Virtual Chassis Control Protocol
Answer: B,C
NEW QUESTION 27
You are responding to an RFP for a services provider that wants to upgrade their MPLS/LDP network to use traffic engineering.
Which two statements are correct in this scenario? (Choose two )
- A. Segment routing uses LDP for label adjacency making it backward-compatible with LDP.
- B. RSVP-TE requires a controller for bandwidth reservations.
- C. Segment routing requires a controller for bandwidth reservations
- D. RSVP-TE creates session states on core routers.
Answer: C,D
NEW QUESTION 28
As a service provider network engineer, you are asked by management design a Layer 2 VPN product with a ''five nines'' SLA.
Which mechanism will address this requirement?
- A. VRRP
- B. GRES
- C. EVPN LAG
- D. SyncE
Answer: A
NEW QUESTION 29
You are designing a solution for a company with a central office with several branch locations geographically dispersed. You are given the following requirements:
- provides a different bandwidth at each location,
- has any-to-any connectivity,
- offloads some network responsibility.
- is inherently isolated.
- has a simple network design.
Which statement satisfies these requirements?
- A. Implement services on a mesh of dark fiber between each location
- B. Implement WAN over the public Internet.
- C. Implement Layer 3 VPN services at each location
- D. Implement Layer 2 VPN point-to-point circuits from each location to the central office.
Answer: D
NEW QUESTION 30
Exhibit.
Which routing protocol design will accomplish these goals?
- A. Enable a full mesh of IBGP sessions between the routers in ISP B.
- B. Configure each router in ISP B to peer with a par of route reflectors.
- C. Redistribute the BGP routes learned from ISP A into the OSPF instance running in ISP B.
- D. Configure static routes to ISP A on each router within ISP B.
Answer: B
NEW QUESTION 31
Exhibit.
Within ISP E, R1 is load-balancing traffic destined to ISP D over the R1-R2-R5 and R1-R4-R5 paths. At some point, a link degradation event occurs in the network as shown in the exhibit. You want R1 to rapidly learn of the path failure.
- A. Enable Bidirectional Forwarding Detection between R1 and R4.
- B. Adjust the OSPF hello timer to a subsecond value between R4 and R5.
- C. Adjust the OSPF hello timer to a subsecond value between R1 and R4.
- D. Enable Bidirectional Forwarding Detection between R4 and R5.
Answer: D
NEW QUESTION 32
Your customer requires virtual machine mobility between two data centers, and they are pursuing a managed service.
Which solution would satisfy the customer's requirement?
- A. an IPsec VPN service between CE routers
- B. a routed service
- C. an L3VPN service
- D. an EVPN service provided over IP
Answer: C
NEW QUESTION 33
What are two ways that allow BGP route reflectors to advertise more optimal IGP next hops? (Choose two)
- A. Implement route reflectors at each POP.
- B. Implement a centralized route reflector.
- C. Use SPRING.
- D. UseBGP-ORR.
Answer: B,D
NEW QUESTION 34
You are creating a WAN solution design for an enterprise customer. The customer will be connecting three sites in different locations. The customer wants all of the sites to be part of the same Layer 2 network.
In this scenario, what are two valid connection methods you would provide in your design? (Choose two.)
- A. NG-MVPN
- B. EVPN
- C. leased line
- D. IPsecVPN
Answer: B,D
NEW QUESTION 35
What are two network management benefits of using devices in your design proposals?
- A. Virtualization can lower costs because there are fewer physical devices that need to be purchased and managed.
- B. Virtualization allows network administrators to dynamically make configuration changes to all network devices.
- C. Virtualization allows network administrators to dynamically add and remove services being provided
- D. Virtualization can increase the available network bandwidth because their interface speeds are only limited by the host device.
Answer: A,C
NEW QUESTION 36
You are creating a WAN solution design for an enterprise customer. The customer will be connecting three sites in different locations. The customer wants all of the sites to be part of the same Layer 2 network.
In this scenario, what are two valid connection methods that you would provide in your design? (Choose two.)
- A. VPLS
- B. Layer 3 VPN
- C. Layer 2 VPN
- D. Internet WAN
Answer: C,D
NEW QUESTION 37
What are two risks when using a source-based RTBH solution? (Choose TWO)
- A. The target of the attack may not support RTBH.
- B. The attacker's address could be unknown.
- C. The attacker address could be a CGNAT address resulting in a larger service outage for users.
- D. The target of an attack would be blocked resulting in a target being offline.
Answer: A,C
NEW QUESTION 38
You are designing a new service provider network and need to select a label distribution mechanism that guides certain types of traffic along specific paths within the network.
Which two label distribution mechanisms would satisfy the requirements? (Choose two.)
- A. LDP
- B. segment routing
- C. RSVP
- D. BGP-LU
Answer: A,C
NEW QUESTION 39
......
Juniper JN0-1362 Test Engine PDF - All Free Dumps: https://www.prepawayexam.com/Juniper/braindumps.JN0-1362.ete.file.html