JNCIP-SP JN0-663 Dumps Full Questions with Free PDF Questions to Pass
100% Updated Juniper JN0-663 Enterprise PDF Dumps
NEW QUESTION 45
Exhibit:
Your network is connected to two different ISPs and you notice that they are using your network for transit traffic.
In this scenario, which two configuration statements will solve this problem? (Choose two.)
- A. set policy-options policy-statement ISP term ROUTES then reject
- B. set policy-options as-path LOCAL-ROUTES "()"
- C. set policy-options as-path LOCAL-ROUTES " (65310 I 65441)+"
- D. set policy-options policy-statement ISP term REST then reject
Answer: B,D
NEW QUESTION 46
Exhibit:
R2 is receiving the same route from R1 and R3. You must ensure that you can load balance traffic for that route.
Referring to the exhibit, which two configuration changes will allow load balancing? (Choose two.)
- A. Configure muitipath under the global BGP configuration.
- B. Configure muitipath under group R1.
- C. Apply the prepend policy as an import policy under group R3.
- D. Apply the prepend policy as an import policy under group R1.
Answer: A,D
NEW QUESTION 47 
Referring to the exhibit, which three statements about route 10.222/16 are correct when using the default BGP advertisement rules? (Choose three)
- A. R1 will prepend AS10 when advertising 10.222/16 to R2.
- B. R7 will advertise 10.222/16 to R9 with itself as the next hop.
- C. R1 will advertise 10.222/16 to R2 with itself as the next hop.
- D. R2 will prepend AS10 when advertising 10.222/16 to R7.
- E. R2 will advertise 10.222/16 to R4 with itself as the next hop.
Answer: B,D,E
NEW QUESTION 48
Exhibit:
CE-1, CE-2, and CE-3 are part of a single VPLS VPN An Ethernet frame has just arrived at PE-3 from CE-3.
It has a source MAC address of CE-3 and a destination MAC address of CE-1. You want to know what PE-3 does with the Ethernet frame.
Referring to the exhibit, which statement is correct?
- A. It drops the packet because the destination MAC address is not in PE-3's MAC table.
- B. It drops the packet because the destination MAC address is not for PE-3.
- C. It forwards the packet to PE-1 only.
- D. It forwards the packet to PE-1 and PE-2.
Answer: D
NEW QUESTION 49
Which two statements about wide and narrow metrics used in IS-IS are correct? (Choose two.)
- A. Wide metrics are sent by default and use 24 bits in TLVs to send information.
- B. Narrow metrics are enabled by default and use 8 bits in TLVs to send information.
- C. Disabling narrow metrics results in external routes being leaked from L1 to L2 areas automatically.
- D. Wide metrics are enabled with the wide-metrics-onlyparameter under protocols isis hierarchy.
Answer: B,D
NEW QUESTION 50
Exhibit:
Which three statements are true about the show pim join output shown in the exhibit? (Choose three.)
- A. This is a source-specific multicast stream. G The multicast receiver is still using the RP to receive the stream.
- B. The multicast stream does not have an RP.
- C. The multicast stream has been configured with a backup path to allow for fast reroute.
- D. The shortest path to the source is through the RP
Answer: B,C,D
NEW QUESTION 51
Exhibit:
A network administrator is migrating from IPv4 to IPv6 and one of the IS-IS adjacencies is not coming up between R1 and R2.
Which action will solve the problem?
- A. Remove topologies ipv6-unicast from protocols isis on R2.
- B. Remove topologies ipv6-unicast from protocols isis on R1.
- C. Configure topologies ipv4-unicast from protocols isis on R2.
- D. Configure an IPv4 address on interface ge-0/0/1 on R1.
Answer: D
NEW QUESTION 52
You recently deployed CoS-based forwarding in your network, which uses OSPF as its IGP You notice that the forwarding of traffic has not changed and is not following the path indicated within your configuration.
In this scenario, which statement explains this behavior?
- A. Load balancing has not been enabled under [edit forwarding-options.
- B. The defined policy has not been applied under [edit class-of-service forwarding-policy
- C. The defined policy references interface names as the next-hops instead of IP addresses.
- D. The defined policy references IP addresses as the next-hops instead of interface names
Answer: D
NEW QUESTION 53
Exhibit:
Referring to the exhibit, you want to make ISP1 your preferred connection for inbound and outbound traffic.
Which two steps will accomplish this task? (Choose two.)
- A. Create an export policy to prepend the ASN on advertised routes and apply it to the EBGP peer on R2.
- B. Create an export policy to prepend the ASN on advertised routes and apply it to the EBGP peer on R1.
- C. Create an export policy setting local-preference 200 and next-hop self and apply it to the IBGP peers on R1.
- D. Create an export policy setting local-preference 200 and next-hop self and apply it to the IBGP peers on R2.
Answer: A,C
NEW QUESTION 54 
All networks shown in the exhibit contain more than one BGP speaker. You operate ISP A and must ensure that Customer Y sends their traffic to you over the directly connected link. Customer Y is not to be used for transit into your network.
What would you do to accomplish this task?
- A. Advertise routes to Customer Y with the custom defined 65535:65535 community.
- B. Advertise routes to Customer Y with the well-known no-export community.
- C. Advertise routes to Customer X with the well-known no-advertise community.
- D. Advertise routes to Customer X with the custom defined 0:0 community.
Answer: B
NEW QUESTION 55
Exhibit:
Referring to the exhibit, hosts in Site 1 and Site 2 are unable to communicate with each other through the Layer 3 VPN.
What is the problem?
- A. The two sites are in the same AS.
- B. The two sites are using the same instance type.
- C. The two sites are using the same route target.
- D. The two sites are using the same route distinguishes.
Answer: A
NEW QUESTION 56
Exhibit:
Referring to the exhibit, you have recently established a Layer 3 VPN between PE-1 and PE-2, connecting the two CE sites. Rowing information is being shared between sites and the customer has two-way communication After adding this VPN to your core network, PE-1 and PE-2 are no longer able to forward traffic to the Internet.
In this scenario, what is the problem?
- A. You must configure a separate internal BGP group on both your PE devices specifically for Internet connectivity.
- B. You must configure the inet-vpn NLRI for the BGP sessions on both your PE devices.
- C. You must configure a multihop external BGP session between your PE devices and the Internet provider's ISP-A device.
- D. You must configure the inet unicast NLRI for the BGP session on both your PE devices.
Answer: D
NEW QUESTION 57
Exhibit:
Referring to the exhibit, which path would traffic passing through R1 take to get.
- A. R1 -> R3 -> R5 -> R6
- B. R1 -> R2 -> R3 -> R6
- C. R1 -> R2 -> R4 -> R6
- D. R1 -> R3 -> R4 -> R6
Answer: A
NEW QUESTION 58
Exhibit.
Referring to the exhibit, which two statements are correct for a route advertised by R1 towards R4? (Choose two )
- A. The AS path is set to 150 by R2
- B. The BGP next hop is set to 192.168.2 2 by R2
- C. The BGP next hop is set to 14.1 1.1 byR2
- D. The AS path is set to null by R2
Answer: C
NEW QUESTION 59
Exhibit:
R1 assigns incoming voice traffic to the ef forwarding class. All other traffic is assigned to the best-effort forwarding class You have configured a CoS re-write rule on R1 to include the correct CoS bit values in packets sent towards R2 You want R2 to classify traffic using the CoS markings created by R1.
Which two configuration steps are necessary to accomplish this task? (Choose two.)
- A. Assign the CoS re-write rule to the ge-0/0/1.0 interface on R2.
- B. Assign the behavior aggregate classifier to the ge-0/0/1.0 interface on R2.
- C. Configure a behavior aggregate classifier on R2.
- D. Configure a CoS re-write rule on R2 and assign matching CoS values.
Answer: A,B
NEW QUESTION 60
Exhibit.
Referring to the exhibit, which command would reduce the size of the OSPF database and corresponding routes?
A)
B)
C)
D)
- A. Option A
- B. Option C
- C. Option B
- D. Option D
Answer: D
NEW QUESTION 61
Exhibit:
You must configure an OSPF virtual link to facilitate communication between Area 0 and Area 20.
Referring to the exhibit, which two addresses should you use as the neighbor IDs of the virtual link endpoints?
(Choose two.)
- A. The address that is associated with R2's xe-1/2/0 interface.
- B. The address that is associated with R2's router ID.
- C. The address that is associated with R4's xe-0/0/1 interface.
- D. The address that is associated with R4's router ID.
Answer: B,D
NEW QUESTION 62
You are configuring a BGP signaled Layer 2 VPN across your MPLS enabled core network.
In this scenario, which statement is correct?
- A. You must ensure that all interfaces within the site's configuration are explicitly defined with their remote site identifier values.
- B. You must use a unique route distinguisher value on all PE devices in your environment.
- C. This type of VPN requires the support of the I2vpn signaling NLRI on all route reflectors and participating PE devices.
- D. This type of VPN is only supported over LSPs that are using traffic-engineering.
Answer: C
NEW QUESTION 63
Exhibit:
Referring to the exhibit, which three statements are correct? (Choose three.)
- A. This route is an EVPN Type-1 route.
- B. This route contains the MAC address of an end host.
- C. The ESI is 00:22:22:22:22:22:22:22:22:22.
- D. The router with the IP address 10.101.100.3 is the originator of this route.
- E. This ESI Auto-Discovery route is used for designated forwarder election.
Answer: A,C,D
NEW QUESTION 64
......
Who should take the Service Provider Routing and Switching, Professional JN0-663 Exam
The Juniper Service Provider Routing and Switching, Professional JN0-663 Exam is an internationally recognized validation that identifies persons who earn it as possessing skilled in Juniper Service Provider Routing and Switching, Professional Certification. If candidates want significant improvement in career growth need enhanced knowledge, skills, and talents. The Juniper Service Provider Routing and Switching, Professional JN0-663 exam provides proof of this advanced knowledge and skill. If a candidate knows associated technologies and skills that are required to pass the Juniper Service Provider Routing and Switching, Professional JN0-663 practice test then he should take this exam.
Use Valid Exam JN0-663 by PrepAwayExam Books For Free Website: https://www.prepawayexam.com/Juniper/braindumps.JN0-663.ete.file.html
Free JNCIP-SP JN0-663 Official Cert Guide PDF Download: https://drive.google.com/open?id=1pfblaJcdqBedJXco3mn5RF0ARgCY7m6C